An expedition motorhome built from a coach needed household power with no campsite hook-up: 220 V for the kitchen and tools, 24 V and 12 V for the vehicle's own circuits, for hours at a time. We built and supplied the whole system turnkey — three 24 V 300 Ah LiFePO₄ batteries totalling 21.6 kWh, a 5 kW sine inverter, three 50 A mains chargers, a charger that runs from the vehicle's alternator, a 12 V converter, and a frame made to the size of the luggage-bay niche it lives in.
The task: a house's worth of power under the floor of a coach
A motorhome that goes where there are no campsites has to carry its own power station. This one is a coach conversion, and the space for that station was a niche in the luggage bay under the floor. The system had to run 220 V appliances of up to 5 kW, feed the 24 V and 12 V circuits, recharge fast from a mains socket when there is one, top up from the engine while driving — and fit that niche as one unit.
What we delivered, turnkey
- Three LiFePO₄ batteries of our build, 24 V 300 Ah each — 21.6 kWh and 900 Ah in total.
- A 5 kW DC–AC pure sine wave inverter for the 220 V circuit.
- Three mains chargers of 50 A each, one per battery.
- An auxiliary charger that runs from the vehicle's alternator, not from the mains.
- A voltage converter for the consumers on a separate 12 V DC circuit.
- A mounting frame made to the size of the luggage-bay niche, with all the switching and protection on it.
The system at a glance
| Part | Specification |
|---|---|
| Batteries | 3 × LiFePO₄, 24 V 300 Ah, 7.2 kWh each (20.0–29.2 V working range) |
| Total storage | 900 Ah at 24 V = 21.6 kWh |
| Per-battery limits | 200 A discharge, 100 A charge (from the labels) |
| AC output | 220 V, up to 5 kW, pure sine wave |
| DC outputs | 24 V up to 2.5 kW; 12 V up to 600 W |
| Mains charging | 3 × 50 A chargers; 0–100% from 6 hours |
| Charging on the road | DC–DC charger from the alternator (label: 24 V to 24 V, 50 A), maintaining charge |
| Frame | aluminium profile, sized to the luggage-bay niche |
How long it runs
These are the runtimes on the 220 V circuit with the bank full, as we specified them for the customer:
| Continuous load | Runtime |
|---|---|
| 5.0 kW | about 4.3 hours |
| 3.5 kW | about 6.2 hours |
| 2.0 kW | about 10.8 hours |
They are the bank's stored energy divided by the load. In real use the inverter's own losses and a reserve left in the batteries take some of that off, and a motorhome rarely draws 5 kW for hours: a kettle or an induction hob runs for minutes, an air conditioner cycles. So the hours in daily life are usually longer than the table's top row suggests.
The batteries: three 24 V 300 Ah packs
Each battery is a single row of large prismatic LiFePO₄ cells in series — the label's 29.2 V maximum is eight cells at 3.65 V — held between end plates and strapped into one block, with its BMS and wiring along the top. The blocks are wrapped in blue heat-shrink cases with yellow insulating sheets at the ends; the power leads and an illuminated push-button come out of the end window. Each one is labelled 24.0 V, 300 Ah, 7.2 kWh, with a 200 A discharge and a 100 A charge limit.
Three batteries instead of one large one was a deliberate choice. Each pack is a manageable size to handle and service on its own. The 5 kW load is shared: at 24 V the inverter draws 210–230 A, so each battery gives roughly 70–75 A — about a third of its 200 A limit, which keeps the cells cool. And each battery has its own 50 A mains charger, so all three charge at once and none waits for the others.
The frame and the switchgear
The frame is built from aluminium profile on the dimensions of the luggage-bay niche. The three batteries stand side by side on the lower level, each in its own bay, on tinted transparent panels. The upper deck carries everything else, laid out so every part can be seen and reached:
- the 5 kW pure sine inverter, with its display and two 220 V sockets;
- the DC–DC charger that takes power from the vehicle's alternator;
- the 24 V to 12 V converter in a finned aluminium case;
- resettable DC circuit breakers — 300 A, 200 A, 100 A and 60 A — for the separate circuits;
- two rotary battery isolator switches, to cut the bank off completely for service or storage;
- covered positive and negative busbars where the circuits meet, and heavy-duty plug connectors for the battery leads.
Charging: mains, and the engine on the road
At a campsite or a house, the three 50 A mains chargers put 150 A into the bank together, which takes a supply of about 5 kW — more than one household socket gives. 900 Ah ÷ 150 A gives the six hours from empty to full that we specify, a little more with the final top-off. On the road the alternator takes over through a DC–DC charger. Its 50 A is not meant to refill 21.6 kWh in a day's drive; it keeps the bank topped up while the engine runs and the fridge and the lights keep drawing. A DC–DC charger, rather than a direct link to the starter battery, protects both sides: the vehicle's electrics see a controlled load, and the lithium bank gets the charge profile it needs.
Results
The customer received a complete power station in one frame: 220 V up to 5 kW, 24 V up to 2.5 kW and 12 V up to 600 W, from 21.6 kWh of LiFePO₄, rechargeable from empty in about six hours from the mains and kept topped up from the engine. It is one unit, sized to its niche, with every breaker and isolator on its upper deck. Like every battery we ship, each pack was load-tested before it left the workshop.
What it means for a caravan or motorhome in the UAE and the GCC
Caravans and expedition vehicles in the Gulf face a heavier load than in cooler places: air conditioning, which is the first thing a 5 kW inverter and a large bank are for. The same architecture fits a desert camper, a caravan for weekends in the mountains, or a mobile office or clinic on a truck chassis. Two things change here. The batteries should sit where engine and exhaust heat do not reach them, with air around them, because heat is one of the main things that shortens battery life. And the 220 V side of a habitable vehicle has its own installation rules, in IEC 60364-7-721 for caravans and motor caravans, which your installer follows. The batteries themselves are industrial packs in the sense of IEC 62619, and LiFePO₄'s thermal and chemical stability is why we use it inside a vehicle people sleep in.
See caravan and RV batteries and off-grid power in the UAE & GCC for how we size these systems, 24 V bus and truck batteries for the vehicle side, our 20 kW UPS project for a larger stationary bank, and our delivery terms. Lithium batteries travel as Class 9 dangerous goods and their design must pass the UN 38.3 transport tests. To plan your own, send us your load list and the size of the space.
Frequently asked questions
How big a battery does a motorhome or caravan need?
Add up the watts of what you run and the hours you run it. This expedition vehicle has 21.6 kWh: about 4.3 hours at a full 5 kW, or nearly 11 hours at 2 kW, before inverter losses and reserve. A weekend caravan with lights, a fridge and fans may need a fraction of that; air conditioning is what makes a bank large.
Can a 5 kW inverter run air conditioning in a caravan?
It can, as long as the air conditioner and everything else running at the same time stay within 5 kW, the start-up surge included, and the battery bank can supply the current. Check the unit's rated and starting power with us. On this 24 V system 5 kW means 210–230 A, shared by three batteries.
Why three 24 V batteries instead of one big one?
Each 24 V 300 Ah pack is easier to handle and service on its own, the load is shared so each battery works at about a third of its limit, and each has its own charger, so the whole bank charges at once.
Can the batteries charge while driving?
Yes. A DC–DC charger takes power from the vehicle's alternator — 50 A on this system — and keeps the bank topped up on the road. For a full charge from empty, the three mains chargers do it in about six hours.
Will LiFePO₄ batteries cope with the heat in a vehicle in the Gulf?
LiFePO₄ is more thermally and chemically stable than the common NMC and NCA chemistries, which is why we use it. It still ages faster when hot, so mount the batteries away from engine and exhaust heat, with air around them.
Do you build caravan and motorhome power systems in the UAE?
Yes. We build and test the batteries in Dubai and deliver across the UAE, Saudi Arabia, Qatar, Kuwait, Bahrain and Oman. Send us your load list and the size of the space; the build time is in the quote.
Sources
- IEC 60364-7-721:2017 — Electrical installations in caravans and motor caravans — requirements for the electrical circuits and equipment of caravans and motor caravans
- IEC 62619:2022 — Safety requirements for secondary lithium cells and batteries for use in industrial applications — covers stationary and motive industrial batteries
- Intertek — UN 38.3 testing — the T1–T8 transport tests lithium batteries must pass
- Lithium iron phosphate battery — Wikipedia — LiFePO₄ thermal and chemical stability, 3.2 V nominal cell voltage


